Smart toilet buttocks wash no reaction there are many reasons, there may be small water pressure does not come, there may be spray wash is broken, if you use smart toilet wash buttocks did not react, you can see the reasons and solutions provided by the site.
First, smart toilet buttock wash did not respond to what is going on
Can the lower body wash be used normally? If you can use it, carefully observe whether the buttocks are thin and the nozzle head is pressed with water at the beginning, and consider the nozzle blockage.
The water supply will divide the water and provide different parts of the water, of course, not all of them. If blocked, find a professional to clean up, do not try to clean up yourself, easy to produce damage, higher maintenance costs.
Second, the reason why the smart toilet does not wash the buttocks
The water outlet does not spray water, this problem is relatively easy to solve, you can observe whether there is no water in the water or whether there is a problem with the water pipe, if there is a problem with the water pipe, it is recommended to go to the maintenance point for maintenance.
Clean the head of the water spray, if not for a short time, this is the pressurization design of the smart toilet lid, because the design of the water tank is sealed, there is no pressurization valve, and depends on the pressure of the tap water itself, so in the household water pressure, there is not much impact. If the cleaning head is sprayed with a large amount of water for a long time, it indicates that the water quality is poor, and it is recommended to find a local after-sales office to replace it.
Third, the smart toilet has no reaction after plugging
Check the power supply, computer board and panel, if the power supply is active, observe whether the reset button of the plug has an indicator light, and whether the various parts are in good contact.
1. Water is not heated
Check the remote control, tank heating tube and computer board. If the temperature set by the remote control is normal, wait about ten minutes to see if the two ends of the tank heater circuit are properly connected. If the above two components are normal, it is a problem with the water tank. You can replace the tank and check again.
2. Seat ring cannot be heated
Check the remote control, seat ring heating wire and temperature sensor, etc., and then use the remote control to set the temperature for testing. If not heated, check the resistance at both ends of the seat ring heating wire. If no, check the temperature sensor and replace the seat ring. After the replacement, check whether the temperature sensor works properly.