We know that the simple shower room has a simple structure, simple and generous, transparent sense, and can keep the bathroom dry and wet separation, very suitable for installation in the small bathroom. So in the decoration, the owner will install a simple shower room in the bathroom. Next, I will introduce the simple shower room installation method, as well as the simple shower room cleaning method.
How to install simple shower room
1. Install the bottom basin:
Combine the parts of the bottom basin, adjust the level of the bottom basin, to ensure that there is no water in the basin and the bottom of the basin. The hose can be extended with the distance, the pelvic floor and the floor drain firmly connected.
2. Test and protection:
After loading, it is necessary to test the water to ensure unimpeded launching. Locate and drill holes: Use a pencil and level to determine the drilling positions for aluminum against the wall, and use a hammer drill to drill holes.
3. Install aluminum:
Insert a rubber pellet into the hole and lock the aluminum strip to the wall with screws.
4. Fixed glass:
The glass clamp is locked in the bottom basin borehole, and then fixed with screws.
5. Installation of pipe jacking:
Find the corresponding position above the fixed glass to drill holes, install (straight/diagonal) fixed seat and connect the pipe jacking. Attach it to the top of the glass with a bend sleeve.
6. Installation shelf:
Install the shelf in the measured position, tighten the laminate nut, fix the laminate glass, and keep it vertical and horizontal. Be careful to waterproof the glass under the aluminum.
7. Install movable door:
Install the hardware of the movable door and install the hinge in the reserved hole of the fixed door. After installation, adjust the position of the lotus leaf core, until the door feels the best.
8, do a good job of waterproof:
Install suction strips or water retaining adhesive strips on the side or bottom of the glass as required. Use silicone to close the joints between aluminum and wall, glass and bottom basin.
9. Debugging and fastening:
Check whether each part is comfortable and smooth, and adjust in time if any problem is found. After the adjustment, tighten the corresponding screws to make the whole shower room more firm.
10. Finishing Work:
The decorative aluminum strip is inserted into the aluminum material attached to the wall to ensure that its appearance is neat and generous. Finally, wipe the whole shower room clean with a rag.
How to clean a simple shower room
1, conventional cleaning with water
Shower room glass will inevitably be stained with bath products and water stains, at this time you need to clean with water, it is best to wipe with a soft cloth, soft cloth can be purchased without hair, so that it will not be stained with fiber on the glass.
2. Clean glass water regularly
Shower room glass how to clean is not a simple problem, in addition to regular water, but also need glass water regularly cleaning. Glass water is usually dedicated to cleaning glass and glass related products, used in the shower room should be considered “symptomatic”. According to the application instructions, we first spray the glass horizontally on the surface of the glass, and then wipe it clean with a soft dry cloth. It is best to choose a dry soft cloth that will not lose hair, or prepare a few more pieces, or dry soft cloth wet, fall down the small pile on the glass; The smell of glass water is not very noticeable. General supermarkets have glass water for everyone to choose.
3. If there is dirt, please wipe with neutral cleaning cloth and soft cloth
Shower room glass how to clean the problem must still have some skills, we should remember, must be neutral detergent, so the damage to the glass is less. Tough stains can be removed with a small amount of alcohol. Do not use acid, alkaline solvent cleaning.
The above is to introduce the simple shower room installation method, and simple shower room cleaning method, everyone is clear?
