HOMENews

Shower leakage how to do shower head blocked how to clean up

Shower leakage how to do shower head blocked how to clean up

2023-09-09 01:09:22

How to do if the shower leaks

1. Water leakage occurs at the connection between the nozzle and the handle

If such a situation occurs, first unscrew the handle from the pipe, of course, it should be noted that if the use of ordinary wrench, to tape the hose, to prevent it from being scratched, and the binding clamp is not necessary, then clean the thread on the handle, and on all sides of the adhesive, and finally turn the shower back, and hand to tighten it, remove all excess adhesive and tape.

2. Leakage at the steering ball of the shower head

Unscrew the nozzle from the ball ring, find out the internal O-ring or seal, replace it again, and then screw it back to the original position, if it is found that the shower is leaking because of internal sand or sediment, the nozzle should be unscrew from the steering ball, and then clean up.

Two, how to clean the shower head blocked

To deal with nozzle blockage, first look at what material the nozzle is made of. If the nozzle is made of metal, it is likely to be caused by serious rust in the nozzle, and after the nozzle is removed, the garbage in the nozzle is forcibly dumped out. It is then cleaned with a metal anti-rust and rust removal lubricant, which allows the metal to have better permeability. Separate the rust layer from the metal layer and leave a protective film so that the shower will never rust again.

In addition to the use of rust removal lubricants, you can also use a needle to clean up the clogged spray hole, the fine needle can penetrate the clogged spray hole, but also can clean up the impurities blocking the spray hole. This method is relatively simple, but when using it, you need to be careful not to puncture the rubber ring inside the nozzle, and do not try it if you are not sure!

There is also a better cleaning method, you can choose white vinegar, white vinegar sterilization effect is very good. First prepare a plastic bag, pour household white vinegar into the plastic bag, and then wrap the plastic bag after the shower head, pour the vinegar in the basin so that the shower head can be submerged. Wrap a night after, then take it off, so it can effectively deal with the nozzle blockage and sterilization!

It can be seen that the shower head is blocked and needs to be properly cleaned up. If the nozzle is made of metal, it is likely to be caused by serious rust in the nozzle. After the nozzle is removed, the garbage in the nozzle is forcibly dumped out first, and then the metal anti-rust lubricant is used to clean up.