Many friends must think that the installation of the shower can be done by a decoration master, and there is no need to worry. If you think like this, the installed shower head will be fixed there like cement, and it will be very troublesome to change the position again. I have a certain understanding of the installation, and I can design it in combination with my own bathroom decoration. Next, the editor will introduce the shower installation method and common problems for you.
The installation height of the shower can be divided into two types according to the type of shower:
Concealed showers, the distance between the center of the water outlet buried on the wall and the ground should be 2.1 meters, and the distance between the center of the shower switch and the ground should be 1.1 meters; The best is 2 meters.
The surface-mounted shower switch and the buried water pipe are hot on the left and cold on the right, and the distance between the centers should be 150cm. face at a 90-degree angle. It should be noted that these data are only average data, and the actual installation of the shower should be adjusted according to the height of the user.
There are two reasons why the fine water in the shower turns into mixed water of coarse and fine. One is that the spraying method of your shower is adjustable. You can rotate the nozzle to adjust it. If it is not the reason for adjustment, it is caused by too much dirt in the nozzle If it is caused, open a small round cap in the middle of the nozzle with a small flat screwdriver, turn on the shower, rinse it with clean water, brush the shower hole with a toothbrush, and then install and restore it.
There are two types of shower spouts on the market now, one is made of hard material, and the dirt can only be removed with a cleaning needle when cleaning. There is also a soft material, usually silicone, which can remove dirt by hand. The latter is recommended.
