Toilet decoration is a very important item in home decoration, but also a complex and cumbersome decoration, decoration has a lot of details need to pay attention to, if you ignore these details, the comfort and security will be greatly reduced, the quality of life in the future home caused a great impact. So it is not too much to say that details determine success or failure and perfection.
There are several aspects of the construction details of the decoration. The threshold, waterproof, floor tile, circuit, wall and floor drain are the key parts. The details and skills of the construction help to better realize the decoration effect.
1. Threshold construction skills
The threshold is the passage of the bathroom, which plays the role of waterproofing and dividing the space. It also has the meaning of accumulating money in school. The key point of the construction design of the threshold is to pay attention to the inner slope of the plane on the threshold, so that the moisture can smoothly slide to the floor drain inside the bathroom. The second key point of threshold construction is to be the same width as the door frame, and the door frame must be the same thickness as the wall, so that the size can be the same when laying the floor tile, which is very effective in preventing breaks.
2, ground waterproof construction skills
At present, the waterproof material used in the ground is mainly waterproof agent. When laying waterproof layer, it should be spread to 20 centimeters above the foot of the wall. The height of waterproof layer can not be lower than the height of the threshold. When the floor oil is reserved, the waterproof layer should keep the reserved pipe. After the waterproof layer is done and dried, cement mortar should be used immediately to prevent the damage of the waterproof layer.
3. Lay floor tile details
When laying the floor tile, pay attention to the joint thickness of the floor tile, and to align with the wall tile joint; The floor tile should have a drainage slope. If you install a bathtub in the bathroom, the front wall of the bathtub must be made of brick tiles. The floor tile should be attached to the bottom of the wall first, and then attached to the wall brick, so as not to have a break.
4. Details of circuit laying
Tin should be hung between the wire joints, and waterproof tape and insulating tape should be used successively to ensure safety and place leakage. All wires must be covered with flame retardant tubes, switches and sockets with moisture proof boxes, or installed in a dry area.
5, wall brick details
The wall should also be moisture-proof and waterproof before pasting the brick. When pasting the brick, the wall should be smooth, and the seam and alignment must be made with the floor tile to ensure the overall sense of the wall and the ground.
6. Details of floor drain construction
Generally, when the new house is handed over, the reserved hole of drainage is relatively large, which requires attention to repair the reserved hole of drainage, so that it is consistent with the floor drain bought back. In order to prevent the entry of dirt such as hair, sludge and sand, the opening aperture of the floor drain grate should be controlled between 6-8mm.
