The fast heating electric water heater brings users a simple and comfortable experience, low energy consumption, and easy to use, and is welcomed by users and friends. As people continue to pay attention to safety issues, the installation and use of electric water heaters can avoid many unsafe problems. So what is the installation diagram of the fast-heating electric water heater? Below, the editor will bring you the precautions for the installation and use of the fast-heating electric water heater!
Improper installation and use of fast-heating electric water heaters will cause the product to fail to work normally and cause consumers to misunderstand the quality of the product itself. Therefore, it is necessary to pay attention to the following four items:
(1) Install the filter
The instant water heater must be installed with a filter screen at the water inlet, because there is a small amount of debris in the tap water, so as not to get stuck on the floating magnet (dry heating, no heating) or block the shower (the water outlet is getting smaller and smaller). If the filter screen is clogged, the flow rate will be reduced, the water output will be smaller, and the floating magnet will not work, and the water heater will not be able to heat. After using it for a period of time, remove the filter for cleaning and then use it.
(2) Check the position of the “floating magnet”
When installing the water heater, the staff must remember to check whether the “floating magnet” is at the lower end, so that it is in a state of free movement, so as to ensure the normal use of the water heater. Because the floating magnet is a water and electricity linkage switch, turn on the water valve to automatically heat up, turn off the water to stop heating, if there is debris stuck on the floating magnet, the water heater will appear dry or not heating, and the debris on the floating magnet will be removed to normal Work.
(3) No mixing valve
The instant electric water heater does not need to use a water mixing valve, because if the water mixing valve is hit in the middle, there will be a mixture of cold and hot water flowing out at the same time. Temperature (thermostat action), the water will be hot and cold phenomenon. The staff should inform customers who use the water mixing valve to turn on the machine directly to the hot water end without mixing cold water, so that the service life of the product will be longer and it will not be easy to scale.
(4) Control water flow
When installing the water heater, you must use the special shower provided by the manufacturer. Under normal working conditions, the water heater can adjust the water flow or increase the water temperature. However, most users do not have the habit of controlling the flow of the faucet, resulting in the water temperature not reaching the predetermined effect.
The relevant information of the fast-heating electric water heater has been introduced here. I believe that everyone has a certain understanding of the correct installation of the fast-heating electric water heater! I hope it can be helpful to everyone.
