With the hot sales of Gree air-energy water heaters, Gree air-energy water heaters have also entered more and more families. For owners who need to buy, what are the advantages of Gree air-energy water heaters? How should Gree air-energy water heaters be installed? The following is to clear up your doubts.
Advantages of Gree air energy water heater
1. Safety: No gas is used, no waste gas will be produced, and there will be no “gas poisoning”; no electric heating rods are used for heating, and there will be no danger of electric leakage, taking care of the health and safety of family members.
2. Save money: the COP value is more than 3, the energy efficiency ratio is high, absolutely saving electricity and money. It can save 2/3 to 3/4 of electricity expenses, or 1/2 to 2/3 of gas expenses and auxiliary heating expenses of solar water heaters.
3. Comfort: patented technology – over-flow indirect heating, automatic constant temperature and pressure water supply, never hot and cold when using hot water, hot water has pressure, and the comfort is good. All-weather, all-year-round water supply makes up for the embarrassment of the solar water heating system that there is no hot water available in rainy days, nights, no sunlight, and freezing.
4. Environmental protection: the cold air discharged from the air (heat pump) water heater is beneficial to lower the room temperature.
Gree air energy water heater installation method
Gree air-energy water heaters can be installed in multiple places in the room, such as enclosed balconies, outdoor terraces, kitchens, and bathrooms. However, for our daily life, in order to use it more conveniently, we generally choose the location closest to the kitchen under the same conditions, because the kitchen uses the most hot water. If it cannot be installed near the kitchen, then choose a location near the bathroom, which will be more convenient to use.
The water pipes of Gree air energy water heaters generally use 6-point pipes (25PPR pipes), but the screw ports should choose 4-point pipes, so as to avoid uneven water temperature. In addition, the instrument should be installed close to the air energy water heater, and be careful to avoid being exposed to rain.
To test the water heater, connect the cold water pipe first, then connect the cold water pipe to the water inlet at the safety valve position, then fill the water tank with water after the hot water pipe is connected, and close the valve when water flows out from the hot water port; Connect the drainage device to drain the condensed water generated during use. After the installation is ready, plug in the power cord to run the water heater, check whether there is any abnormality in the water pipes, fans, instruments and other components, and turn off the power after running for about ten minutes without abnormality. The entire water heater system has been installed, and then it can be powered on and run to enjoy the convenience it brings.
The above is a brief overview of whether Gree air-energy water heater is good and how to install it. I think everyone knows how to install it. I remind you not to forget to use electricity safely while enjoying the convenience. I hope it can be helpful to everyone.
