HOMENews

Electric heating faucet installation procedure

Electric heating faucet installation procedure

2023-07-07 09:07:20

In the cold winter, the hot water at home must be enough, but if you want to open the faucet all the hot water comes out, it is afraid to use the electric faucet. Electric faucets have the advantages that water heaters and solar energy cannot compare, although they can also produce hot water, but the water in the water pipe is still cool, so you need to finish the water in the water pipe before you can have hot water to use.

The electric faucet allows you to turn on the tap and have hot water. The so-called electric faucet is what we usually say is a fast heating faucet, which is heated by instant electricity, so that the water coming out of the faucet is hot. As a new product, how to install the electric faucet?

Step 1: First remove the original popular faucet

First of all, we must close the valve of the water pipe, remove the original non-electric water hose, wash and clean the pipe interface with clean water to prevent excessive rust and the formation of infarction.

Step 2: Assemble the parts

1. First, the elbow pipe of the electric heating faucet is adjacent to the body of the electric heating faucet, and the mechanical reliability is OK.

2. If you want to use a washbasin, then unscrew the nut of the body inlet and put the electric faucet firmly on the washbasin; Skip this step if you don’t need a wash basin.

3. Then, the electric heating faucet is adjacent to the water pipe.

Step three: Check

1. After installing the electric heating faucet, open the water valve switch first and check whether the connector can leak.

2. Then open the electric heating faucet switch, release water to the machine, and open and debug the hot and cold water switch several times.

3. After thoroughly rolling out the air bubbles in the machine, plug in the power supply.

4. Adjust the hot water to the desired position, because the temperature of the hot water is adjusted by the hot water size control switch. A red light will signal the split to heat up.

Hot water faucet installation points:

1. After the electric heating faucet device is completed, the water should be first passed and then energized. Rotate the handle up and down, see that there is water flowing out of the water outlet, and then turn on the power supply to use. (First use only).

2, the electric heating faucet has two kinds of cold and hot water flow, when the hot water is cut off, there is no need to plug out the power supply frequently.

3, the electric heating faucet accepts pressure installation, the switch to the hot water deviation automatically start heating, hit the cold water does not cost any electricity. Use simple, save water and electricity.

The above is the detailed installation steps of the electric heating faucet, after the installation, you can use the hot water in an unusually convenient way, as usual open the faucet 3-5 seconds time can let you use the warm hot water, no longer need to be affected by the cold, and it is also unusually small and convenient, is a good deputy in your home.