Whether it is the decoration of the living room, the decoration of the bedroom or the decoration of the bathroom, it should not be perfunctory. For example, the decoration of the bathroom also requires a clean, water and electricity safe space to make the whole house more neat and comfortable. Next, the editor of the website will talk about the installation of water pipes in the rough room bathroom and the precautions for water pipe installation. Friends who are interested can take a look and hope to provide help for everyone.
1. Installation of water pipes in the bathroom of the blank room
1. After the water pipe is installed, a pressurization test must be carried out: the pressurization test is generally carried out at 1.5 times the water pressure, and there should be no water leakage during the test.
2. A simple test method without pressurized conditions, but not entirely feasible.
1) Close the main valve of the water pipe. (that is, the water pipe switch in front of the water meter)
2) Turn on the faucet in the room for 20 minutes, make sure that there is no water and then turn off all the faucets.
3) Turn off the water inlet switches of equipment with water storage functions such as toilet tanks and washing machines.
4) Open the main valve of the water pipe.
5) Check whether the water meter moves 20 minutes after opening the main valve, including slow movement. If there is movement, it is a water leak. If it’s not moving around, it’s probably fine. (If there is a problem with the water meter or micro-seepage of the water pipe, it may be difficult to determine.) Therefore, it is recommended that the water pressure test must be carried out after the construction. Generally, the pressure is 8 kg and the time is 20-30 minutes.
3. Water pipe direction: It is recommended that the water pipe go to the top to be the safest. The main reason is that most of the waterway reconstruction is through hidden pipes, and the characteristic of water is that water flows to low places. If the pipeline goes underground, it is difficult to find out the water leakage in time. Only when the water overflows the Jinshan Mountain or the floor is deformed and leaks to the downstairs, will the water leak be found, and it is difficult to find the place of the water leakage because the water pipe is buried in the ground. At this time, the huge loss is even more irreparable, and even seriously affects the friendly neighborhood relationship; if the water pipe goes to the top, the cost of water reform may be higher, but as a long-term investment, it is worth it. Even if the water pipe leaks, it can be found in time, which is convenient for maintenance and less loss.
2. Precautions for water pipe installation
1. The bathroom water pipes basically pass through the roof, because this can reduce the chance of man-made damage, and the interface and outlet of the cold and hot pipes must be parallel. Usually, the hot pipe is on the left and the cold pipe is on the right. Shangqiu Decoration Co., Ltd. tries to avoid bending the entire pipeline during design, and it should be transported away from the circuit as much as possible. The position and slope of the pipe clamp should also meet the requirements. Each valve must be installed flat for future use and maintenance.
2. When installing the hot water pipe, it is necessary to distinguish between the water inlet and the water outlet of the water heater. The main valve is connected to the water inlet, and the water outlet is connected to the pipeline leading to the bathroom. After installation, open the valve first to confirm whether there is any water leakage. If the situation occurs, then install the faucet and shower head in the bathroom.
3. The bathroom is the darkest place in the whole family and the place where moisture is most likely to accumulate, so ventilation is particularly critical. It is best if a window can be designed in the bathroom. If there is no such condition, in order to prevent mold and damp bugs in the bathroom phenomenon, in addition to installing exhaust fans, it is also necessary to avoid the occurrence of “wrapping”. Many people like to wrap the pipes in the bathroom tightly, and this happens to cause the moisture to be wrapped in the pipes and cannot escape. So it will make the moisture in the bathroom more serious.
Precautions for water pipe installation in rough room bathroom
What are the problems of decoration? Do you know all about it? I believe that mastering these, you can easily decorate the house.