First, how to install the basin faucet
1, take out the basin faucet, check whether all the accessories are complete, be sure to remove the dirt around the installation hole and the water supply pipe before installation, and ensure that there is no impurity in the basin faucet water inlet pipe. To protect the surface of the faucet from scratches, it is recommended to wear gloves when installing.
2, take out the basin faucet rubber washer, washer is used to relieve the faucet metal surface contact pressure with the ceramic basin, protect the ceramic basin, and then insert a water inlet pipe, and tighten.
3. Thread the threaded connector into the first inlet hose, and then pass the inlet end of the second inlet hose through the threaded connector.
4, screw the second water inlet hose into the water inlet port, pay attention to the correct direction, force balance, and then screw the threaded joint.
5. Thread two water inlet hoses into the white rubber pad.
6. Set the locking nut to fix the faucet.
7. Then tighten the sleeve.
8. Lock the two inlet pipes and Angle valve interfaces respectively. Do not use pipe pliers to twist the plate to prevent deformation or even breaking. Pay attention to the connection of hot and cold water. Connect the other end of the inlet pipe to the outlet Angle valve.
Two, basin faucet leakage how to do
1. If the hot and cold water faucet is controlled by a total water inlet valve, close the total valve. When the hot and cold water inlet pipes are separate, then close the corresponding two valves.
2. Use a flat-mouth screwdriver to open the above illustrated accessory “01 Hot and cold label (handle fixing screw hole plug)”.
3. Use a flat-mouth screwdriver to reach into the handle fixing screw hole plug (hot and cold mark hole), and turn the screwdriver counterclockwise (left) about 3 times.
4, with the left hand to grasp the faucet handle, push upward, at the same time with the screwdriver back handle (must be non-metal material, otherwise it will damage the faucet surface) gently tap upward, so that the accessory “02 water handle” is separated.
5, counterclockwise (left) accessories “03 end cover”, the end cover is separated from the main body.
6. Place the adjustable wrench at the beginning of the accessory “04 core set hex sleeve”, adjust the size of the adjustable wrench at the beginning, rotate counterclockwise, remove the ceramic spool to check, if intact, turn clockwise (right), tighten and stop the force. If damaged, replace the spool with a new one.
7, reinstall the original accessories “03 end cover”, “02 outlet handle”, “01 hot and cold label (note that red represents the hot water side, blue represents the cold water side)”.
It can be seen that the installation of the basin faucet must pay attention to the steps, such as being sure to remove the dirt around the installation hole and in the water supply pipeline before installation, and ensure that there are no impurities in the basin faucet inlet pipe. To protect the surface of the faucet from scratches, it is recommended to wear gloves when installing.
